Xbox 360 JTAG Modded Console

Xbox 360 GENUINE old school JTAG Modded Console NOT RGH

Sold console only . Power supply is extra. See specific item for Hard drive availability. HDDs are available to purchase preloaded !

This item is made to order (unless it shows in stock). I strive to ship made-to-order consoles in 7 days. (Within 4 days if in stock), but if it’s longer I will contact you. I take my work very seriously. I don’t cut corners , and I don’t skimp on the stress testing phase. Your satisfaction is my #1 priority.

Most JTAGable consoles I have are systems that have not been used or updated in many years , and usually had RROD caused by a bad GPU. I fully refurbish these systems ,and a NEW GPU will be installed. We don’t do reballs/reflows or bolt mods here.

Alternatively, if you wanted a rare motherboard variant JTAG , like a Jasper or Opus see below 👇

I can take any console , on any dashboard and make it a JTAG by using a zero fuse cpu (brand new cpu) that was never installed on a console.

I don’t do this unless specifically requested to.

Keep in mind a zero fuse will do everything a JTAG can and more. There’s no need to burn a zero fuse unless you insist on JTAG. So if at all possible let’s keep zero fuse a zero fuse.

If this was done to a particular system it will be noted in the item specific description (select motherboard type) otherwise it was an old system not updated in years.

I must note that a zero fuse cpu is capable of running freeboot as is without any wiring or glitch chips. The only reason to burn the cpu to JTAG would be purely for collector purposes or your personal desire.

The rough process a system goes through to convert it to JTAG is :

-RGH original cpu to obtain cpu key and kv

-Create a fuse blowing nand with the obtained cpu key to burn the new cpu with the appropriate JTAGable CB LDV.

-Create retail blades 6717 dashboard

The serial number in retail form remains the same as shown on the console serial # stickers

-Downgrade dvd drive firmware to work on retail 6717

-JTAG mod the console. Jasper, Tonasket , Falcon/Opus, Zephyr I use the AUD CLAMP + BOXXDR JTAG method

Additionally

-Ultrasonic cleaning of motherboard to remove all flux residues

-DVD drive gets cleaned, lubed, laser checked for function and replaced if needed. New belt.

-Outer plastic console shell gets scrubbed in hot soapy water

-Stress tested for 3 days over multiple thermal cycles

It takes roughly 8-9 hours of labour to create a JTAG console with a new CPU 

Most consoles come with 120gb standard size HDD.

*see specific item description for HDD availability *

Larger HDD are available in various sizes via accessories page

Note:

Xenon, Zephyr and early Falcon consoles have their RROD prone GPUs replaced with revised GPUs that have high tg underfill for maximum reliability and enjoyment.